Load an overhead photo of the octagon, then click the 8 outer-edge corners clockwise from the top.
Fewer than 8 corners — results will be approximate.
② Octagon Dimensions▼
Fighting Area Ø30 ft / 9.1 m
Outer Edge Ø36 ft / 11.0 m
Fence Height5.0 ft / 1.52 m
Door A — wallclockwise from top
Door A — side
Door B — wallclockwise from top
Door B — side
③ Camera Controls▼
POSITION
X (left / right)-14.1 ft
Y (back / forward)-8.9 ft
Z height11.7 ft
ORIENTATION
Yaw55°
Pitch-27°
Field of View60°
DRAG TO LOOK · SCROLL TO MOVE
Compose Shot▼
Click the 3D view to place fighters on the floor. Adjust position and scale with sliders. Camera drag/scroll still works.
JUMP TO SHOT
④ Logo Targets▼
Switch to Mark Mode then drag boxes on the overhead image to define logo regions. Double-click an edge to add a point. Right-click a point to remove it (min 3).
SCROLL TO ZOOM · SHIFT+DRAG TO PAN
⑤ Roboflow Fighters▼
Paste your Roboflow project URL and API key. ⚠ Run locally — blocked inside Claude.
Project URL
API Key
Annotation class name
UPLOAD ZIP MANUALLY
⑥ Export▼
CURRENT VIEW
LOGO-FOCUSED TRAINING SET
Select a logo target, set shot count, then generate a training set where that logo is always at least partially in frame.
Target Logo
Number of shots32
Fighters per shot
Weight class
SHOT MIX
= 100%
standard30%
angled17%
close8%
sameside12%
low5%
distant3%
overhead4%
near5%
logo left8%
logo right8%
Load an image to begin
SELECT FIGHTER CUTOUTS
All cutouts used if none selected
PICK CUTOUT FOR FIGHTER 1
Click a cutout to assign it. Current selection highlighted.